Magmaweld ID 400E Manuel D'utilisation page 11

ID 400E
TECHNICAL INFORMATION
1.1 General Information
ID 400E is an inverter type portable, tri-phase DC MMA welding machine designed to weld stick electrodes
up to 6.0 mm. Due to descending characteristics of the inverter technology it provides stable arc and good
restriking performance. Initial striking ability of the electrodes can be improved via Hot Start potentiometer
and certain electrodes like basic electrodes which have tendency to short circuit and stick to the weld pool
could be avoided by adjusting the Arc Force potentiometer. It can be used as a Touch-Scratch DC TIG welder
if a TIG torch with a valve is connected. ID 400E can also be used with long welding cables up to 25 m. Plus,
wireless and cable remote control options are possible.The machine is fan cooled and thermally protected
against over heating.
1.2 Machine Components
1
2
3
4
1- Current Adjustment Pot
2- Current Display
3- Voltage Display
4- Earth Cable and Welding Cable Socket (+)
5- Hot Start Adjustment Pot
6- Arc Force Adjustment Pot
www.magmaweld.com
9
5
6
10
7
8
7- Welding Mode Selection Button
Figure 1 : ID 400E
8- Earth Cable and Welding Cable Socket (-)
9- Handle
10- Remote Control Connector Inlet
11- ON / OFF Switch
12- Mains Cabla Inlet
Technical Information 11
11
12
USER MANUAL
EN