Publicité
Les langues disponibles
Les langues disponibles
Storage
ALL SAFE...UNTIL NEXT TIME!
Regular Maintenance
Due to the Speed and Performance of your ARRMA vehicle we recommend following the
maintenance guide below:
•
After every few runs check the gluing of the tire to the wheel, clean and re-glue where
required.
Frequently check the whole vehicle for loose or missing screws and fittings. Use thread
•
lock on any replacement screws that fix into metal parts or threads.
•
Remove the wheels occasionally and check behind the wheel mounting hex for debris
that might have been wrapped around the axles and is causing extra drag.
•
Frequently check rotating parts are free from any obstructions such as stones or grass
that might restrict their rotation which can lead to the over stress of the motor or speed
controller.
After 10-15 runs remove the motor from the vehicle, Re-oil the motor shaft bushes with some bush / lightweight
oil, a couple of drops on both bushes will aid the speed and longevity of your motor.
Check the gear mesh and remove any stones, grit or dust from the plastic spur gear teeth and slipper clutch
housing to prevent premature wear and damage.
If the motor is removed for maintenance or servicing, the gear mesh will need to be re-set. Loosen the motor
retaining bolts and adjust the motor position until there is minimal backlash between the pinion and spur gear
teeth. If the mesh is too tight or too loose the gears will be noisy and could result in failure.
The slipper clutch pad is designed to wear very slowly while protecting your driveline, the tension on the slipper
spring will require occasional resetting, and the slipper pad will need replacing periodically.
Over time you may notice increased play in the suspension and steering system. The replacement of the
Composite Pivot Ball Set (AR330515) will restore a tighter tolerance and reduce movement.
The vehicles shock absorbers will wear quicker if used in dirty dusty conditions. Replace oil and seals as
required to keep good shock damping to maintain the performance and handling of your vehicle.
Instructions for the removal of the power module and the setting of the gear mesh and slipper clutch can be
found in the 'Technical Pack' booklet enclosed with your model.
A well maintained vehicle will keep the strength and reliability expected from your ARRMA vehicle.
www.modellmarkt24.ch
18
WWW.ARRMA-RC.COM
Publicité
