TEFAL T-fal ClipsoMinut' Guide De L'utilisateur page 8

Use
Pressure cooking
Opening
Switch the lid handle from a horizontal position to a vertical position
The lid turns.
Lift the lid.
In case of difficulties opening the lid; rinse the gasket under water and
replace it in the lid without drying it
each of the grooves on the lid
Closing
Ensure that the lid handle is in a vertical position.
Place the lid on the pot as indicated in
with the pot handles.
Lower the lid handle back from a vertical position to a horizontal position
Fig. 2.
It is normal that the lid turns on the pot. when the pressure cooker is closed
but not in operation. This effect disappears when it is pressurised.
If you are unable to close the lid:
Check the correct positioning of the gasket.
In case of difficulties closing the lid, rinse the gasket under water and replace
it in the lid without drying it
the grooves on the lid
Using for the first time
For models with a non-stick coating: wash and use cooking oil to lightly oil
the entire interior surface.
Depending on the model:
Put the trivet* (L) and the steam basket*(J) in the pan base.
Clip the trivet* (K) to the steam basket* (J) as shown in the
diagram opposite, then set the assembly in the pan base.
Fill the pot (Q) with water up to 2/3 (MAX 2)
Close your pressure cooker.
Align the pictogram
the valve positioning mark (C)
Stewpot*
- fig 18
- fig 14.
- fig 18 and take care to insert it under each of
- fig 14.
for the operating valve (A) with
- fig 10.
and take care to insert it under
- Fig. 1
by lining up the plastic part
- fig 5.
Steam release
- Fig. 3.
-