TEFAL T-fal ClipsoMinut' Guide De L'utilisateur page 23

Problems
If steam leaks
from around the
lid, check:
If you are unable
to open the lid:
If the food is not
cooked or is bur-
ned, check:
If food has burnt
in your pressure
cooker:
If one of the
overpressure
safety systems is
triggered:
If you notice the
appearance of
oxidation marks on
the exterior (stainless
steel models only)
If you cannot
put the folding
handles * in the
position for use:
If you cannot
fold the folding
handles*:
Recommendations
The correct closure of the lid.
The position of the gasket in the lid.
The condition of the gasket; replace if needed.
The cleanliness of the lid, gasket and its housing in the
lid.
The condition of the edge of the pan.
Check that the pressure indicator (D) ) is in the lowered
position. If not, depressurise by half filling your sink with
cold water and submerge the bottom of your pressure
cooker until the pressure indicator comes down. Never
interfere with the pressure indicator (D).
Turn the operating valve (A) to the position
The cooking time.
The power of the heat source.
The correct position of the operating valve (A).
The quantity of liquid.
Fill the pot with water and soak for a while before
washing.
Never use bleach or chlorine-containing chemicals.
Turn off the heat source.
Let your pressure cooker cool down without moving it.
Wait for the pressure indicator to fall and open the
pressure cooker.
Check and clean the operating valve (A), the steam
release outlet, the safety valve and the gasket.
If the problem persists, have your pressure cooker
checked by a TEFAL/T-FAL Approved Service Centre.
The use of high performance stainless steel does not
prevent the appearance of oxidation in extreme cases.
If you notice oxidation marks, remove them by rubbing
with an abrasive sponge before using your pressure
cooker again.
Check that:
The buttons (M)* are mobile.
If the phenomenon persists, have your product checked
by a TEFAL/T-FAL Approved Service Centre.
Do not force them.
Make sure you press the buttons all the way down*(M).
If the phenomenon persists, have your product checked
by a TEFAL/T-FAL Approved Service Centre.