AEG BPE748380B Notice D'utilisation page 86

Step 1 Fully open the door.
Step 2 Lift and press the clamping levers
(A) on the two door hinges.
Step 3 Close the oven door to the first opening position (approximately 70° angle). Hold the door at both
sides and pull it away from the oven at an upwards angle. Put the door with the outer side down on
a soft cloth on a stable surface.
Step 4 Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
Step 5 Pull the door trim to the front to re‐
move it.
Step 6 Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
Step 7 Clean the glass panel with water
and soap. Dry the glass panel care‐
fully. Do not clean the glass panels
in the dishwasher.
Step 8 After cleaning, do the above steps
in the opposite sequence.
Step 9 Install the smaller panel first, then the larger and the door.
11.6 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
86 ENGLISH
B
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
A
2
Put a cloth on the bottom of the cav‐
A
1
Step 3
ity.