Skil SD561802 Guide D'utilisation page 15

Screw Driving
a) Install a suitable bit.
NOTICE: Always use the correct type and size
of screwdriver bit for your application.
b) To tighten a screw, set the direction of
rotation at "Forward".
c) To loosen a screw, set the direction of
rotation at "Reverse".
d) Grasping only the handle of the tool, align
the bit perpendicular to the screw (Fig.8).
e) Apply just enough pressure to keep the
bit engaged on the screw and depress the
trigger switch to begin screw driving.
NOTICE: The screwdriver may also be used
manually as a non-powered screwdriver without battery power.
NOTICE: Do not over-tighten, as the force of the screwdriver can break the fastener. Keep the
screwdriver at a right angle to the fastener to avoid damaging the fastener head.
Fig. 8
15