Safety Warnings For Screwdriver; Other Safety Instructions - Skil SD561802 Guide D'utilisation

Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or
temperature above 265 °F may cause explosion.
Follow all charging instructions and do not charge the battery pack or tool outside the
temperature range specified in the instructions. Charging improperly or at temperatures
outside the specified range may damage the battery and increase the risk of fire.
Service
Have your power tool serviced by a qualified repair person using only identical
replacement parts . This will ensure that the safety of the power tool is maintained.
Never service damaged battery packs . Service of battery packs should only be performed
by the manufacturer or authorized service providers.

SAFETY WARNINGS FOR SCREWDRIVER

Hold the power tool by insulated gripping surfaces, when performing an operation
where the fastener may contact hidden wiring . Fasteners contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the operator an electric
shock.

OTHER SAFETY INSTRUCTIONS

To reduce the risk of fire or electric shock, carefully follow these
DANGER
instructions .
Before using power supply, read all instructions and cautionary markings on (1) power
supply, (2) battery pack, and (3) product using battery .
Charge battery pack and/or product within the required temperature range. Store power
supply and battery pack in locations where temperature is within the recommended
storage temperature range . This is important to prevent serious damage to the battery cells.
Do not recharge battery in damp or wet environment . Do not expose power supply to
rain or snow . Water entering power supply may result in electric shock or fire.
Battery leakage may occur under extreme usage or temperature conditions . Avoid
contact with skin and eyes . The battery liquid is caustic and could cause chemical burns
to tissues. If liquid comes in contact with skin, wash quickly with soap and water. If the liquid
contacts your eyes, flush them with water for a minimum of 10 minutes and seek medical
attention.
Place power supply on flat nonflammable surfaces and away from flammable materials
when recharging battery pack . Carpeting and other heat insulating surfaces block proper
air circulation which may cause overheating of the power supply and battery pack. If smoke or
melting of the power supply or battery pack is observed, unplug the power supply immediately
and do not use the battery pack or power supply. Contact customer service immediately.
Keep the cord and power supply from heat to prevent damage to housing or internal
parts .
Do not allow gasoline, oils, petroleum-based products, etc . to come in contact with
plastic parts . These materials contain chemicals that can damage, weaken, or destroy
plastic.
Make sure cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress . Damaged plug and cord may result in electric shock or fire.
Disconnect the power supply by pulling the plug rather than the cord . Do not operate
power supply with damaged cord or plug; have them replaced immediately. Damaged
plug or cord may result in electric shock or fire.
Do not insert battery pack in power supply if battery pack case is cracked . Using
damaged battery pack may result in electric shock or fire.
5