Publicité
Les langues disponibles
Les langues disponibles
Step 4: Rotating the motor - For rear venting (horizontal)
• Position the unit on its back on a flat non abrasive surface – perpendicular to your working surface (See Figure #6).
Place hand to hold motor in position and ensure weight of motor is well supported (See Figure #6).
•
This will ensure screws don't get bent or broken.
•
•
Remove 4 screws that hold motor in place on the top side of the hood.
•
Ensure the motor weight is well supported by your hand as the last screw in place may break under the weight of the motor.
•
•
Once the motor is set free from the hood, rotate motor clock wise to position venting outlet with rear rectangular hole, ensuring that:
•
Electric wire is located under the motor as you relocate the motor outlet (See Figure #7).
•
Electric wire is not caught under the motor outlet (See Figure #8).
•
4 holes are aligned with screw holes at the rear.
•
Put unit upside down so the screw holes securing the motor are in a position facing you.
•
Install 4 screws to hold motor – Use a screw driver to perform operation – NOT A DRILL as it may strip the motor housing thread
(See Figure # 9).
Fig # 6
Fig # 8
INSTALLATION:
Fig # 7
Fig # 9
12
Publicité
