Publicité
Les langues disponibles
Les langues disponibles
Step 3: Rear venting (horizontal) using rectangular damper
Preparing Range Hood
•
Remove unit from packaging
•
Position the unit on its back on a flat non abrasive surface - front facing you (See Figure #3)
•
Remove the 2 filters to allow access to the inside of the unit (See Figure #3)
•
Cut tie wraps on motor cables so wires are free to move and be relocated (See Figure #4)
Fig # 3
Remove rear vent back plate
•
Position the unit face down on a flat non abrasive surface with rear of product facing you
•
Remove the back plate by removing the 4 screws (See Figure #5)
SAFETY WARNING: Risk of electrical shock. This range hood must be properly grounded. Make sure
this is done by a qualified electrician in accordance with all applicable national and local electrical codes.
Before connecting wires, switch power off at service panel and lock service panel to prevent power from
INSTALLATION:
Fig # 4
Fig # 5
being switched on accidentally.
11
Publicité
