Ancona AN-1280 Instructions D'utilisateur page 10

Installations ( refer to page 4 for parts):
NOTE: Use threaded drywall anchors only when
mounting the hood on sheet rock. Mounting the hood
on wall studs or lumbars is highly recommended.
For consumer safety reasons, mounting screws and anchors have not been supplied with this
range hood. Different wall and cabinetry construction methods require specific types of screws
and wall anchors. Please consult your installation specialist regarding the best type of mounting
screws and wall anchors to suit your home's construction.
Step 1: Top venting using 6" round damper:
•
If you require 6" round venting, keep the unit as provided in the packaging and install the round damper provided.
• Position the damper on top of the unit and set in place with screws provided (See Figure #1)
• Connect duct work to damper.
• Use Duct Tape to ensure joint is sealed and air tight.
Fig # 1
Step 2: T op venting using rectangular damper
• If you require rectangular top (vertical) venting simply
• install the rectangular damper p rovided (See Figure #2). Connect duct work to damper.
• Use Duct Tape to ensure joint is sealed and air tight.
INSTALLATION:
g # 4
Fig # 2
10 10
g # 4