Angelo Po 0N0SPE Manuel D'utilisation page 31

SAFETY
HAZARDS AND SAFETY PROVISIONS DURING SERVICING
During servicing, watch out for the following hazards and provide for the countermeasures
indicated below:
► Source of hazard: appliance mechanics
Hazard
Risk of cutting due
to sharp edges
► Source of hazard: risks associated with the environment in which the appliance is used
Hazard
Presence of satu-
rated steam
NOTE: Only applies to electrical appliances.
► Source of hazard: electric power
Where or in which situations
Hazard
does the hazard occur?
Risk of electric • Under protective panels
shock caused by
• Under the control panel
live components
• Under protection covers
3269941_GB_rev.1
Where or in which situations
does the hazard occur?
When handling sheet-metal
parts
Where or in which situations
does the hazard occur?
Condensation and dripping
on electrical parts
Countermeasures
• Pay special care during
this activity
• Wear personal protective
equipment in accordance
with safety regulations
Countermeasures
• Periodic servicing of the
appliance wiring diagram,
to be carried out only by
expert technicians of an
authorised customer ser-
vice
Countermeasures
• Operations to the electric
system may be carried out
by authorised and quali-
fi ed staff only, in accor-
dance with the relevant
applicable laws.
• Specialist procedure
• Comply with the correct
installation requirements
as per section "Installing
the appliance" of the in-
stallation manual.
• Disable the power supply
before removing the pro-
tections
ENGLISH
Safety
device
None
Safety
device
None
Safety device
• P r o t e c t i o n
panels
• S y s t e m
s w i t c h - d i s -
connector
9