Angelo Po 0N0SPE Manuel D'utilisation page 127

ADJUSTMENTS
WARNING: Before commissioning the
appliance, the system must be tested to as-
sess the operating conditions of every sin-
gle component and detect any anomalies.
In this stage, it is important to check that all
health and safety requirements are strictly
adhered to.
The following checks should be carried out to
test the system:
INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS
The appliance's main functions do not require
any special adjustments by specialist staff ex-
cept the settings made during use by the user.
INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS
The appliance does not require the replace-
ment of operating components by specialist
staff except the replacement of standard parts
which can be carried out by the user.
APPLIANCE DECOMMISSIONING, SCRAPPING AND DISPOSAL
NOTE: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during decom-
missioning.
When decommissioning the appliance, a set
of procedures should be carried out to ensure
that the appliance and its components are not
a hindrance and are not easily accessible.
To prevent the appliance from posing risks to
people or the environment, disconnect and
disable all energy sources (electricity, etc.), and
drain any liquids (lubricants, oils, etc.).
3269941_inst_GB_rev.1
TESTING OF THE APPLIANCE
ADJUSTMENTS
REPLACING PARTS
Check that the mains voltage is the same as
)
that of the appliance.
Operate the automatic switch-disconnector
)
to check the connection to the power supply.
If necessary, after testing, train the user by pro-
viding all skills required to safely commission
the appliance, in accordance with applicable
legal requirements.
Place the appliance in a suitable and not easily
accessible area, with barriers to prevent anyone
from accessing it.
When scrapping, sort all components by chem-
ical characteristics and dispose of them sepa-
rately in accordance with the relevant applica-
ble laws.
!MPORTANT:Never dump non-bio-
degradable materials, lubricating oils and
non-ferrous metal components (rubber,
PVC, etc.) in the environment. Dispose of
them in accordance with the applicable laws.
ENGLISH
11