Cleaning - shark RIDILL Manuel D'utilisation

TEXTILE PARTS - CLEANING
THE TEXTILES
The RIDILL make it easy for you to appre-
ciate fully the performance of your helmet.
The parts in contact with the skin are made
in a fabric that is guaranteed to feel pleasant,
to absorb perspiration well and to resist wear
satisfactorily. We treat surfaces to limit the
risk of mould and bacteria.
WARNING! Although they are selected
for their quality of resistance and satis-
factory wear, all the interior padding is subject
to normal wear depending on use and care
and maintenance, the length of use and also
the degree of acidity of your perspiration. If
you note any wear, we
advise you to replace the interior padding
in order to keep your helmet perfectly clean
and comfortable.
Your SHARK supplier can propose you with
replacement parts and also offer you cheek
pads of different thicknesses and densities,
should the standard selection not correspond
to the contours of your face.
16
Manuel Ridill.indd 16
CLEANING THE INTERIOR
The interior textile parts are washable; it is im-
portant to follow the instructions below scru-
pulously to avoid damaging them:
The cheek pads and head section must be
hand washed in warm, soapy water (about
Do not use aggressive detergents but
30°).
either a product for delicate materials in
low dilution or household soap.
to dry textile and foam parts completely before
using them. They must be dried at room tem-
perature. Never iron textile parts. For parts with
a leather appearance or textiles attached to
safety elements, use a slightly damp sponge or
cloth and household soap and rinse with clean
Avoid allowing too much water to
water.
come into contact with polystyrene parts.
WARNING! It is essential to ensure that
all interior parts are perfectly dry before
using the helmet.
It is essential
31/08/2016 15:41