Ferrite Core *Europe Only - Star TSP200 Guide D'utilisation

3-2. Ferrite Core
NOTE: Take special care when following the procedures listed below.
A ferrite core noise filter for the
peripheral unit cable comes packed
with the printer.
The ferrite core is normally packed
so it is opened, as shown in Fig. 3-2.
If you find that the ferrite core is not
opened: Use a pointed object to pry
the plastic lock of the ferrite core
apart, as shown in Fig. 3-1. When
opening it, take care not to damage
the ferrite core or the plastic lock.
Ferrite Core (28mm diameter)
One loop
Fig. 3-2
*Europe only
• Pass the fastener through the ferrite
• Pass the fastener around the cable
Cut off the excess with a pair of scis-
sors.
– 5 –
Fig. 3-1
core.
Fig. 3-3
and lock it.
Fig. 3-4
Fastener
Pull and cut