Maintenance; Faults And How To Remedy - Wolf Garten Campus 320 E Mode D'emploi

Emptying of Grassbox
The grassbox is full and should be emptied as soon as grass clip-
pings remain uncollected on the ground behind your mower.
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Empty collection bag.
Remove potential blockages in the cutting space before
starting.

Maintenance

General
1
Caution! Rotating cutters
Before all maintenance and cleaning tasks:
Pull the mains plug out.
Take care not to grab running cutters.
Cleaning
Always clean the lawnmower after each use with a handbrush.
Never spray the mower with water.
Storage
At the end of each mowing season, you should perform a
complete cleaning operation on the mower.

Faults and how to remedy

Problem
Running rough, heavy
vibration of the unit
Motor will not run
Poor mowing/collection
If you are not sure, then always consult the WOLF service workshop.
Caution! Switch the mower off and pull the mains plug out before checking or working on the cutters.
G
Possible cause
• Cutter faulty
• Cutter has come loose in the fixings
• House fuse faulty
• Cable damage:
1
Caution! Risk of electrocution from damaged
cables
The fuse does not always respond if the cable is cut
or damaged.
Do not touch the cable before the plug has been
removed from the plug socket.
Damaged cables should be replaced completely
It is prohibited to mend the cable using insulating
tape.
• Cutters blunt
• Collection basket blocked
• Inappropriate cutting height
The mower should be checked by a WOLF customer service
workshop in the autumn.
Store the mower in a dry room.
Changing the cutters
When performing any work on the cutters, coupling and cutter
beam, pull the plug out and wear protective gloves.
1
Caution!
After the cutters have been sharpened there could be imba-
lance.
Always have the cutters sharpened by a specialist work-
shop, since a balance test in accordance with the safety
regulations must be carried out.
Always have the cutters changed by a specialist workshop.
Use only original WOLF spare parts.
Service Workshop
M
Help from (X)
WOLF
Self
X ---
--- X
--- X
X ---
X ---
--- X
--- X
13