Publicité
Les langues disponibles
Les langues disponibles
ANGLE TRANSMISSION(Fig.22)
Lubricate with lithium-based grease.
Remove the screw (1) and put in the grease, turning the shaft manually until
grease emerges, then replace the screw (1).
REPAIRS
Only an authorized service centre should repair the machine.
Problem
Check
Fuel at the
carburetor
The engine
Fuel at the
stalls, is
cylinder
difficult to
start or does
not start
Sparks at
the spark
plug
electrodes
Sparks at
the spark
Fig.22
Condition
The fuel does not arrive
at the carburetor
The fuel does not arrive
at the cylinder
There is fuel in the
exhaust
There is no spark
There is no spark
GB
Cause
Fuel filter
blocked
Fuel supply
blocked
Carburetor
Carburetor
The fuel mixture
is too rich
Switch in "O"
position
Electrical
problem
Locked switch
Bad spacing of
the electrodes
30
Solution
Clean or replace
Clean or replace
Ask your distributor for
advice
Ask your distributor for
advice
Open the throttle valve
Clean or replace the air
filter
Ask your distributor for
advice
Set the switch to the ON
position (Run)
Ask your distributor for
advice
Adjust the gap to 0,6~0.7
mm
Publicité
