Bestgreen BCI43U Traduction Des Instructions D'origine page 84

GB
Fit the Nylon cutting head.(Fig.7)
Remove another shield after release the nut. Still hold the flange, take the Nylon cutting
head on the shaft and rotate counter-clockwise, the Nylon cutting head is fitted.
Fig.7
Release the Nylon cutting head.(Fig.8)
Use screw driver to hold flange and then rotate the Nylon cutting head clockwise till it is
well fixed, it will be replaced.
Fig.8
Replacing cutting line.(Fig.9)
Stop the engine, follow the sequence below.
Fig.9
17