Bestgreen BCI43U Traduction Des Instructions D'origine page 88

3) T o start a cold engine, move the choke lever to the
a warm engine, leave the choke lever in the run position. (fig.14)
Close the choke: Start position
Position: air filter cover
4) Slowly pull the recoil starter until you feel it engage and then pull it quickly. till it
starts.( (fig.15)
Attention: Check and make sure cutting attachment always stops when the engine
is idling.
Note: when the engine is started for the first time. It will require a number of
attempts to start until the fuel travelled from the tank to the motor.
5) Turn the choke lever to the run position as the engine started.(Fig.16)
6) After starting the engine, let the engine run for 2 to 3 minutes so that it warms up
before subjecting it to any load.
7) Hot start: When the machine is hot,stays the choke level in "Start position", the user
can start the machine by repeating steps of 1,2,4.
Fig.14
Fig.15
21
GB
position. In order to restart
Fig.16