Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
WARNING!
Please ensure that the brush cutter is switched off properly and that the engine has
stopped completely before assembly and adjustment.
Assembly of the handl e (Fig.1-1,1-2,1-3)
Fig.1-1
1) Remove the screws infixing device and remove the upper cover.（fig.1-1）
2) Place the handle in position and assemble the upper cover.(fig.1-2)
3) Assemble and tighten the screw.(fig.1-3)
4)
CAUTION!
Do not tighten the screws until you have set the handle in optimal working position.
Please always adjust the handle position with full assembled accessories.
The black cable tie can be used to fix the throttle cable to the metal tube. (Fig.2)
Assembly the guard (Fig.3-1, Fig.3-2)
1) Place the guard on the fixture.（fig3-1）
2) Assemble and tighten the screws.（fig.3-2）
Fig.3-1
GB
Fig.1-2
Fig.2
Fig.3-2
14
Fig.1-3
Publicité
