Panels Mounting; Door And Bottom-Drawer Overlay Panels Layout - Bertazzoni REF75PIXL Guide D'installation

4. PANELS MOUNTING

4.1 Door and Bottom-Drawer overlay
panels layout
The dimensions of the panels are indicated in the
table and drawings on pages 13.
Nevertheless, according to the requirements for
aligning with other kitchen structures, the door pa-
nel can be higher than the upper edge of the re-
frigerator door, and the drawer panel can be lower
than the edge of the drawer.
The panels must be mounted using special braces
which attach to adjustable devices provided on the
door and drawer and with brackets that anchor and
adjust the panel's vertical direction.
Braces, brackets and fixing screws are provided
with the appliance and must be applied to the panel
as indicated.
Operate as follows:
To prepare the panels to be mounted on the ap-
pliance, follow these steps, working on the back of
the panel.
Door panel
> Draw a reference center line, dividing the panel
width in half [ 1 ].
>
Starting from the bottom edge of the panel, mark
the positioning of the brackets
> Following the corresponding table, mark the out-
side and then the inside
10
[ 2 ].
hole[ 3 ].
www.universal.bertazzoni.com
> Position the brackets on each set of marks to
make sure they are aligned
drill pilot holes (pay close attention to the panel's
thickness) [ 5 ]
> Screw the brackets in place
5
Drawer panel
>
When preparing the Drawer Panel, follow the
1
same instructions as per the door panel, but make
sure measurements are taken starting from the top
edge[ 7 ]. The support bracket faces the opposite
way [ 8 ] (note imgs 4 and 8).
2
3
[ 4 ], you may wish to
[ 6 ].
4
6
7
8