Installation Into A Cabinet; Mounting The Cabinet Door(S) - Bertazzoni REF24BMBPNB Manuel D'installation Et D'utilisation

4.3 Installation into a cabinet

With the help of one or two other people, move
the appliance into the cabinet. There are two
metal plates at the base of the appliance. Fit the
supplied white spacers to these plates.
1. Insert the appliance into the column cabinet,
placing it on the opposite side of with respect
to the hinges, and make sure there is a gap of
1/8"-13/64".
2. After checking the alignment of appliance door
and cabinet door, mount the plastic covers from
the accessories bag.
top
3. Tighten the screws for the appliance's lower
part.
bottom
4. Fit the seal onto the appliance, cutting off any
excess as necessary. Mount the plastic covers
on the bottom parts.
5. Use a Phillips-head screwdriver to loosen the
connecting pin underneath the right middle
hinge, and adjust it to screw onto the right
cabinet wall.

4.4 Mounting the cabinet door(s)

> Ensure that there is a gap of 1/8'' to 5/32'' (3 to
4mm) between the non-hinged side of the fridge
and the cabinet wall.
> Locate the slider in the bracket and mount the
slider on the cabinet door, 51/64'' to 7/8'' (20 to
22mm) from the door's long edge, as shown in
the following image, ensuring that the slider is
positioned centrally and horizontally within the
bracket. Tighten securely by hand.
> Fill the gap on the non-hinged side with the
gasket/sealing strip provided.
> The finished look for the door sliders should be
similar to those shown in the following image,
which shows 2 sliders in place.
Ensure the appliance doors open, close and seal
properly.
Once complete, and if you are happy with the fit of
the appliance in the cabinet, bend and snap off the
parts of the white spacers marked 'S', as shown by
the dotted outline.
Leave the remaining portions of the spacer covers
in place over the metal plates.
EN
11