Operation With The Remote Control - Danby DAS120GAHWDB Manuel Du Propriétaire

OPERATING INSTRUCTIONS

OPERATION WITH THE REMOTE CONTROL

• The air conditioner will not operate if curtains, doors or other materials block the signal from the
remote control to the indoor appliance.
• Do not expose the remote control to water, direct sunlight or excessive heat.
• Do not allow direct sunlight to fall on the infrared receiver on the indoor appliance as this can impede
the signal from the remote control.
• Remote signal reception is confi rmed with a beep.
SET: Used to increase or decrease the temperature setting in 1°
increments. Pressing and holding these buttons can reach the
desired temperature faster.
ON/OFF: Press to turn the appliance on or off.
MODE: Press to select the desired operating mode.
TURBO: Press to activate the turbo function, which will run the
appliance continuously to reach the preset temperature in the
shortest amount of time.
SPEED: Press to set the desired fan speed.
SLEEP: Press to activate sleep mode which conserves energy
during sleeping hours.
°C/°F: Press to change the temperature scale between °C and
°F.
DISPLAY: Press to turn the display on or off.
SWING: Press to start or stop the horizontal and vertical louver
swing feature. The direction of the arrow indicates which louver
is being controlled.
iFEEL: Press to activate iFEEL mode which will adjust the set
temperature automatically.
ANTI-F: Press to set the anti-F feature which will run the fan for
a short period after the appliance turns off to ensure the interior
of the appliance is dry and does not produce a musty smell.
iCLEAN: Press when the appliance is turned off to activate
iCLEAN.
TIMER: Press to set the automatic timer.
Remote Control Specifi cations
Model
Rated Voltage
Signal Receiving
Range
Environment
4
YKR-H/101E
3.0V (dry batteries
R03/LR03x2)
8m (26 feet)
-5°C to 60°C (23°F
to 140°F)