Danby DAS120GAHWDB Manuel Du Propriétaire page 11

CARE & MAINTENANCE
CLEANING THE OUTDOOR APPLIANCE
Any cleaning, maintenance or repairs of the
outdoor appliance must be completed by a licensed
HVAC technician. Contact the dealer who sold
the appliance for information on maintenance or
repairs to the outdoor appliance.
CLEANING THE INDOOR APPLIANCE
Note: Always turn off the air conditioner and
disconnect the power source before cleaning the
appliance or removing the fi lter.
• Use a soft, dry cloth to clean the outside of the
appliance. If the appliance is especially dirty,
use a cloth soaked in warm water to clean the
outside of the appliance.
• Do not use water to clean the inside of the
appliance as this can destroy the insulation and
cause electric shock.
• Do not use chemicals or chemically treated
cloths to clean the appliance.
• Do not use benzene, paint thinner or other
solvents to clean the appliance. They can cause
the plastic surface to crack or deform.
• Do not use water hotter than 40°C (104°F) to
clean the front panel. This can cause the panel
to deform or become discoloured.
PRE-SEASON INSPECTION
After a long period of non-use or before a period of
frequent use, complete the following:
1. Check for damaged wires.
2. Clean all fi lters.
3. Check for leaks.
4. Replace the remote control batteries.
5. Ensure nothing is blocking air inlets and outlets.
Ensure nothing is in the way of the infrared
remote receiver.
LONG PERIODS OF NON USE
If the air conditioner will not be used for a long
period of time, complete the following:
1. Turn on the Anti-F function and allow it to run
until the appliance is completely dry.
2. Turn off the appliance and disconnect the power.
3. Clean and replace all fi lters.
4. Remove the batteries from the remote control.
DISPOSAL
Check for local regulatory compliance regarding the
approved and safe disposal of this appliance.
ERROR CODES
If an error code appears in the display window, the
appliance may stop operation as a safety feature.
Wait approximately 10 minutes as the error may
resolve itself. If the error code persists, disconnect
the power to the appliance, wait approximately 5
minutes and then restore power to the appliance.
If the error persists after the power cycle, contact the
sales center where the appliance was purchased for
information on servicing the appliance.
10