Replacing The Remote Batteries - Danby DAS120GAHWDB Manuel Du Propriétaire

OPERATING INSTRUCTIONS

REPLACING THE REMOTE BATTERIES

The appliance comes with two AAA batteries. Place the batteries in the
remote control before use.
1. Slide the back cover from the remote downward to expose the battery
compartment.
2. Insert the batteries, ensure to match the (+) and (-) symbols on the ends
of the batteries with the symbols inside the battery compartment.
3. Slide the battery cover back into place.
• Do not mix old and new batteries or batteries of different types.
• Do not leave the batteries in the remote control if it is not going to be
used for more than 2 months.
• Do not dispose of batteries as unsorted municipal waste. Collection of
such waste separately for special treatment is necessary.
• Removing the batteries from the remote will erase all previous
programming. After inserting new batteries, the settings on the
appliance must be reprogrammed.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
4. Consult the dealer or an experienced radio/TV technician for help
Changes or modifi cations not approved by the party responsible for FCC compliance could void the user's
authority to operate the equipment. This appliance complies with Part 15 of the FCC Rules and Industry
Canada's license-exempt RSS.
Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
This device complies with Canadian CAN ICES-3 (B) / NMB-3 (B)
8