Operation Of Wireless Remote Control; Remote Control Functions - Danby DPAC8011S Guide D'utilisation Et Soins De Propriètaire

Operation of wireless remote control

REMOTE CONTROL
FUNCTIONS
Remote Control
ON/OFF
MODE
Names and functions on the remote control.
NOTE: Be sure that there are no obstructions between receiver and
remote controller; Don't drop or throw the remote control, Don't get the
remote control wet, do not put the remote control directly under the sun-
light or any place where it is very hot.
ON/OFF Button
•
Press this button, the unit will be
turned on, press it once more, the
unit will be turned off. When turning
on or turning off the unit, the Timer
Sleep function will be canceled, but
the presetting time will still remain.
MODE Button
•
Press this button, Auto, Cool, Dry,
Fan and Heat mode can be select-
ed. Auto mode is default while the
power is on. Under Auto mode,the
temperature will not be displayed;
Under Heat mode, the initial value is
28°C (82°F) under other modes, the
initial value is 25°C (77°F).
AUTO COOL
DRY
HEAT FAN
AUTO
COOL
DRY
FAN
HEAT
Only on some units. (optional)
SLEEP
SLEEP Button
•
Press this button, Sleep On and
Sleep Off can be selected. Once
the unit is powered on, Sleep Off is
the default setting . Wehn the unit is
turned off, the Sleep function is can-
celed. After the Sleep function set
up, the symbol of Sleep will display.
In this mode the timer can be
adjusted. Under Fan and Auto
modes this function is not available.
FAN
FAN Button
• By pressing this key, you may
select AUTO, FAN 1, FAN 2, FAN 3
or FAN 4 and may also cycle
between them. FAN 4 is only avail-
able in cool mode. After being ener-
gized AUTO is the default setting.
Only the LOW fan can be set under
DRY mode, pressing this key can
not adjust the fan speed but can
send the signal.
AUTO
Fan 1
Fan 3
SWING
SWING Button
• Press this key to activate or deacti-
vate the swing. Moving of the lou-
vers allow cooled air to change
direction.
9
Fan 2
Fan 4