Helios KWL EC 1200 S Pro/WW Notice D'installation Et D'utilisation page 68

Installation and Operating Instructions
EN
+
NOTE
Central Ventilation Units KWL EC.. S Pro/WW
– Filter
The KWL compact unit is equipped with fine filters on the outside and extract air side as standard (DIN EN 13779):
• Outside air/extract air:
Repl. air filter F5 extract air 1pc.
Repl. air filter F7 supply air 1pc.
Repl. air filter F5 extract air 1pc.
Repl. air filter F7 supply air 1pc.
Repl. air filter F5 extract air 1pc.
Repl. air filter F7 supply air 1pc.
Repl. air filter F5 extract air 1pc.
Repl. air filter F7 supply air 1pc.
The internal pressure-dependent filter monitoring system signals the necessty of inspection and cleaning or filter
replacement on the controller. Irrespective of this, a 3-month inspection is recommended. They must be exchanged for
hygiene reasons after one year of operation at the latest. If the filters are damp or mouldy, they must be exchanged
immediately.
Replacement air filters are also available online at www.ersatzluftfilter.de!
6.3 Reset function
The manual RESET takes place by pressing the reset lever (Fig.21/22), which is located directly on the electrical pre-he-
ater. Proceed as follows:
1. Depending on the installation situation, remove one of the two side inspection covers.
2. For a manual RESET, push the reset lever upward (Fig.22)
6.4 Removal of warm water heater battery
1. Dismantle the cross-flow heat exchanger as described in section 6.1
2. Loosen the fixing screws of the warm water heater battery (Fig.23)
3. Carefully remove the frost protection sensor (Fig.24/25)
4. Loosen the water connections and remove the warm water heater battery (Fig.26)
(1)
ELF-KWL 800S/5 VDI No. 8256
ELF-KWL 800S/7 VDI No. 8257
ELF-KWL 1200S/5 VDI
No. 8347
ELF-KWL 1200S/7 VDI
No. 8348
ELF-KWL 1800S/5 VDI
No. 8258
ELF-KWL 1800S/7 VDI No. 8259
ELF-KWL 2600S/5 VDI No. 8308
ELF-KWL 2600S/7 VDI No. 8325
Fig.21
Reset lever
Elec. pre-heater
Cover
Fig.23
Fig.25
28
Fig.22
Fig.24
Fig.26