Publicité
Les langues disponibles
Les langues disponibles
USE OF THE GUN (OPTION)
- Select the GUN tool using the button
- Fix the earth pad firmly and as close to the weld as possible.
In the case of a monopoint weld, always place the earth on the sheet/panel that is not in contact with the welding electrode (in order for the current
to go through the two sheets to be welded).
- Weld starting with the furthest spot away from the earth and work towards it.
- The normal welding mode using the stars is the one used by default.
- The gun can be used in normal or manual mode.
Press the
button for 2 seconds to get back to the NORMAL mode.
42
GYSPOT PTI PREMIUM PRO
.
Attach the gun grounding cable to the mobile electrode. Slide and tighten the knurl.
Connect the control cable to the jack plug.
Check that the screw connecting the shoe to the cable lug is tight.
In normal mode, the gun will be limited to 1.5mm thick sheets.
Using the gun, the operator can choose between different tools (mono point, star, impact, heat, dowel pin,
rivet, nut, toothed wheel). Select the desired tool using the + and - keys.
In Manual mode, the maximum possible intensity is 8 kA for a maximum duration of 500 ms. The settings
showing on the screen will not exceed these values.
Set the generator by indicating the thickness of the sheet/panel to weld using + and - keys. It is possible to
adjust the current and time settings when in manual mode.
Remove the arm from the clamp and fix, in its place, the gun cable.
EN
Publicité
