To Operate The Product; Power Boost Function - Husqvarna 220iL Manuel D'utilisation

To operate the product

To trim the grass
• Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass.
To clear grass
1. Keep the trimmer head above the ground.
2. Tilt the trimmer head.
3. Cut with the end of the trimmer line around objects in
the work area.
CAUTION: Cut grass. Other objects that
are hit by the trimmer line, increases the
wear on the trimmer line.
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.
14
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer line to
prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.
To extend the trimmer line
• When the trimmer line becomes short during
operation, tap the trimmer head on a hard, flat
surface to extend more trimmer line out. You must
operate the product at full speed to get the best
result.

Power boost function

You can use the standard mode or the power boost
function.
• Standard mode: The product is set to standard mode
when started. Standard mode saves energy and
gives maximum operation time. Standard mode is
applicable for most tasks.
• Power boost function: The power boost function lets
the product operate at high speed. The power boost
function can for example be used in areas with
thicker grass growth than usual.
To start and stop the power boost function
You can start or stop the power boost function while the
product is in operation.
1511 - 003 - 06.11.2020