To Start The Product - Husqvarna 430LS Manuel D'utilisation

3. Move the choke control to the choke position.
WARNING:
position when the engine starts, the
cutting attachment starts to rotate
immediately.

To start the product

WARNING:
instructions in the safety chapter before you
start the product. Refer to
instructions on page 4 .
WARNING:
to rotate when the engine starts if the choke
is activated.
1. Use protective gloves.
12
If the choke is in choke
Read the warning
General safety
The cutting head will start
2. Hold the throttle trigger lockout (A) and the throttle
trigger (B) with your left hand. Pull the starter rope
handle quickly with your right hand until the engine
fires. Release the throttle trigger after the engine
starts.
CAUTION:
WARNING:
rope around your hand.
CAUTION:
rope to full extension and do not let go of
the starter rope handle.
3. Reset the choke when the engine fires.
4. Let the engine become warm before you operate the
product.
5. Make sure the engine runs smoothly.
Note:
If the rpm of the engine does not increase,
open and close the choke again.
A
B
Do not use your feet!
Do not twist the starter
Do not pull the starter
1738 - 001 - 26.10.2021