Battery Information; To Start The Product; To Operate The Product - Husqvarna 520iLX Manuel D'utilisation

3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
4. When all LEDs on the battery come on, the battery is
fully charged.
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
12
Only use Husqvarna
If the battery does not

Battery information

Refer to the operator's manual of the battery for
information about how to use the battery.

To start the product

1. Press and hold the start/stop button until the green
LED is lit.
2. Use the power trigger to control the speed.

To operate the product

To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass.
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
To clear grass
1. Keep the trimmer head above the ground.
2. Tilt the trimmer head.
3. Cut with the end of the trimmer line around objects in
the work area.
CAUTION:
that are hit by the trimmer line, increases
the wear on the trimmer line.
Cut grass. Other objects
756 - 007 -