To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna 220iL Manuel D'utilisation

• Push power boost button. The power boost function
is on when the LED is on.
• Push power boost button. The power boost function
is off when the LED is off.
Note: If the power trigger is released during operation,
the product starts in the last set function. If the product
automatically stops, or if the operator pushes the power
button, the product is set to the standard function again
when started.
To change the direction of rotation of the
trimmer head
You can change the direction of rotation at full speed or
at stop position. At start, the trimmer head is set to turn
clockwise.
• Push the left button (A) to set the direction of rotation
to counterclockwise.
A
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
1511 - 003 - 06.11.2020
•
Note: It is easier to tap out the trimmer line to make it
longer when the trimmer head turns clockwise.
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if the product is not used. The green
LED for start/stop indication goes off and the product
stops after 120 seconds.

To stop the product

1. Release the power trigger or the power trigger
2. Push the power button until the green LED is off.
3. Push the release buttons on the battery and pull the
B

Maintenance

Maintenance schedule

The following is a list of the maintenance steps that you
must do on the product. See
more information.
Push the right button (B) to set the direction of
rotation to clockwise. The green LED shows the
direction of rotation that is used.
lockout.
battery out.
WARNING: Remove the battery before you
do maintenance.
Introduction on page 15 for
15