Operation - Husqvarna 220iL Manuel D'utilisation

To assemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Push in the lock button (A) and push the shaft into
the shaft coupling until the lock button sets in the
hole (B).
Note: If you cannot push the shaft fully into the shaft
coupling, turn shaft to make the internal drive shafts
connect.
3. Tighten the knob fully, before you operate the
product.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
12
B
A

Operation

To disassemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Push and hold the lock button (A). Pull the shafts
apart.
To attach the cutting attachment guard
• Attach the cutting attachment guard (A) to the shaft
(C) with the screws (B).
B
C
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
• Do an overhaul of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
B
A
A
1511 - 003 - 06.11.2020