Allen + Roth 0699544 Mode D'emploi page 8

ASSEMBLY INSTRUCTIONS
12. Still with the help of another person, flip the assembly
upright and move to desired location. Once you are
assured that it will not interfere with any water or drain
lines, use a pencil (not included) to mark the pre-drilled
holes on upper cross (D) onto the wall. Set assembly
aside.
Use a 3/16-in. drill bit (not included) to drill 1/4-in. pilot
holes at the marked locations. Insert anchors (OO) into
holes until they are flush with the wall, then move
assembly back into position. Secure item to the wall by
inserting the M3.5 x 40 mm screws (NN) through upper
cross (D) and into the anchors (OO).
WARNING: This step is REQUIRED to ensure the stability
of the item.
Hardware Used
NN M3.5 x 40 mm Screw
OO
Anchor
13. Insert shelf supports (KK) into corresponding holes inside
assembly. Carefully place shelf (E) onto shelf supports
(KK).
Assembly is now complete.
Hardware Used
KK
Shelf Support
12
x 2
x 2
13
x 4
8
OO
A
A
E
Lowes.com/allenandroth
NN
KK
™