IKRA PCS 4040 Manuel D'utilisation page 34

Cutter setting standards:
WARNING
Be sure to wear safety gloves.
Before filing:
• Make sure the saw chain is held securely.
• Make sure the engine is stopped.
• Use a round file of proper size for your chain.
Chain type:
PCS 4040: Oregon 91P/Carlton N1C
File size: 4.0 mm
Place your file on the cutter and push straight forward.
Keep the file position as illustrated.
After every cutter has been set, check the depth gauge
and file it to the proper level as illustrated.
WARNING
Be sure to round off the front edge to reduce the chance
of kickback or tie-strap breakage.
GB | Operating Instructions
Make sure every cutter has the same length and edge
angles as shown below.
Guide bar
• Reverse the bar occasionally to prevent partial wear.
• The bar rail should always be a square. Check for
15
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between them,
the rail is normal. Otherwise, the bar rail is worn. Such
a bar needs to be corrected or replaced.
1) Appropriate
gauge checker
2) Make the shoul-
der round
3) Depth gauge
standard
4) Cutting length
5) Filling angle
6) Side plate angle
7) Top plate cutting
angle