Forest-Master Shown FM10TW Mode D'emploi page 35

Remove nut &
bolt and keep
4. Attach the wheels (12) to the axle bars(3).
Place a washer (15) onto the axle. Place the wheel
(12) over the axle then secure in place with a split
pin (8). Ensure the ends of the split pin are opened
up and bent back around the axle after inserting.
Place a dome (11) cap over the end of the axle and
tap into place with a rubber or wooden mallet.
FM5, FM8 & FM10 (Versions D, T & TW)
3. Remove the M8 x 35 bolt and M8 nut that joins
the two leg sections and remove the lower part of
the leg. Keep this nut and bolt as they are used to
attach the front leg mount to the front leg.
Keep the front leg in case at any time you wish to
remove the splitter from the stand and use it at
ground level.
NOTE: The FM5 and FM8 may have a different front
leg to that shown. In this case the M8 x 35 bolt and
M8 nut will be in with the stand nuts and bolts.
35