Forest-Master Shown FM10TW Mode D'emploi page 28

10T STAND ASSEMBLY
1. Before starting assembly, ensure the log
splitter is disconnected from the power supply.
Ensure the bleed screw on the log splitter is
closed.
If you have someone to assist you in turning the
log splitter over then it may be easier to attach
the stand to the log splitter with the splitter
upside down.
Alternatively you can prop the log splitter
vertically against a wall, with the motor end at
the bottom. Then when assembled it can be
lowered to the ground with the wheels acting as
a pivot.
28
HUB CAP
CIRCLIP
2. Remove the rear wheels from the log splitter.
Prise the hubcaps off with a flat bladed screwdriver.
They are push on not screw on.
Remove the retaining circlip from the groove using either
a pair of circlip pliers or a small flat bladed electricians
screwdriver. If using a screwdriver, insert it into a gap
between the circlip and axle, lever one end off then the
other. Retain the circlips for attaching the wheels to the
stand.
Remove the wheels.
FM5, FM8 & FM10 (Versions D, T & TW)