Forest-Master Shown FM10TW Mode D'emploi page 31

8. Attach the longitudinal beam(4) to the front leg and
the assembled wheel cross beam, using the remaining
2 of the M8x15 bolts(5). Note that the bolts tighten
against the longitudinal beam, there are no holes in it.
Note that the stand is designed to fit the FM5, FM8
& FM10 log splitters, therefore the longitudinal beam
will protrude out the rear of the wheel cross beam. For
the FM5 & FM8, the longitudinal beam can be cut in
length to shorten it if desired. For the FM8 it can be
cut to 600mm and for the FM5 530mm. A standard
hacksaw should be used if cutting the beam.
The log splitter can now be rotated to the upright
position from the position in which the stand has been
assembled. Depending on which splitter you have ,
this may require two persons.
FM5, FM8 & FM10 (Versions D, T & TW)
7. Attach the stand front leg(2) to the log splitter
using the 4 bolts and 4 nuts that where removed
from the short front leg in step 3.
31