Forest-Master Shown FM10TW Mode D'emploi page 12

Attach the longer of the two plain guard panels to
the left side of the work bench and the rear cage
panel. The bottom rear corner has two closely
spaced holes, the top rear corner has a single
hole approximately 10mm from the rear edge.
Do not fasten the top rear corner at this stage.
Use 5 M6x12 button head bolts, 10 M6 flat
washers (1 under each bolt head and 1 under
each nut) and 5 M6 nyloc nuts. Leave all nuts and
bolts finger tight until the last step, this makes it
easier to adjust the cage.
M6X12 SOCKET HEAD BOLT
M6 FLAT WASHER
12
M6 FLAT WASHER
M6 NYLOC NUT
Do not add a nut
and bolt at
stage.
Attach the shorter of the two plain guard panels to the
right side of the work bench. For the orientation of the
panel see the diagram below.
Use 3 M6x12 button head bolts, 6 M6 flat washers (1
under each bolt head and 1 under each nut) and 3 M6
nyloc nuts.
30
20
FM5, FM8 & FM10 (Versions D, T & TW)
this
TOP
BOTTOM
30
20