Forest-Master Shown FM10TW Mode D'emploi page 30

6. Attach the rear axle bar and wheel assembly
to the rear legs using 2 of the M8 x 15 bolts(5).
Note that there are no holes in the rear legs
for the bolts. The bolts tighten up against the
legs.
30
5. Attach the rear legs(1) to the wheel carriage
of the log splitter. The axles of the carriage go
through the large holes in the legs. Secure them
to the sides of the wheel frame using the 2 M8x20
cap head bolts(6) and two M8 nuts(7). Insert the
bolts through the hole in the leg flange and the
hole in the side of the wheel carriage. The nuts go
inside the wheel carriage.
FM5, FM8 & FM10 (Versions D, T & TW)