Gong FEELX Guide De L'utilisateur page 36

GOOD TO KNOW:
>⃝●
If the kite moves backward when you sheet in, it is facing an oversheeting phenomenon. You must
accordingly shorten your front lines by trimming gradually.
>⃝●
If the kite no longer responds to bar actions, your front lines are too short compared to your overly slack back
lines. Therefore, you need to lengthen the front lines by releasing the trim.
These phenomena may arise from an improper match between your bar and your kite. Our kites are all preset
to be perfectly compatible with lines of identical lengths. In some cases, your lines may become slack due to
strong constraints. Remember to check the length of your lines.
SWIVEL
Your bar is equipped with a manual swivel located at the base of the depower line. If your front lines are twisted,
turn it until they are no longer in contact.
EN
- 36