Télécharger Imprimer la page

Atag VA5114BT Mode D'emploi page 49

Publicité

Les langues disponibles

Les langues disponibles

Problem and alarm code
The programme does not
start.
The appliance does not fill
with water.
The lights related to the
programme buttons flash
1 time intermittently.
An acoustic signal
sounds intermittently.
The appliance does not
drain the water.
The lights related to the
programme buttons flash
2 times intermittently.
An acoustic signal
sounds intermittently.
The anti-flood device is on.
The lights related to the
programme buttons flash
3 times intermittently.
An acoustic signal
sounds intermittently.
Malfunction of the water lev‐
el detection sensor.
The lights related to the
programme buttons flash
4 times intermittently.
An acoustic signal
sounds intermittently.
Malfunction of the wash
pump or the drain pump.
The lights related to the
programme buttons flash
5 times intermittently.
An acoustic signal
sounds intermittently.
Possible cause and solution
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the
end of the countdown.
The appliance recharges the resin inside the water soften‐
er. The duration of the procedure is approximately 5 mi‐
nutes.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authori‐
ty.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the interior filter system is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap.
Make sure that the appliance is correctly installed.
Make sure the baskets are loaded as instructed in the user
manual.
Make sure that the filters are clean.
Switch the appliance off and on.
Switch the appliance off and on.
49

Publicité

loading