Janome 9002D Livret D'instructions page 18

Janome 9002D Instruction Manual
4
5
6
2
www.toews.com
16
1
2
4
3
2
1
6
1
Changing Needle
Turn off the power switch and unplug the machine.
Raise the needle to its highest position.
Then loosen the left or right needle clamp screw for the
needle you are going to remove.
1
Needle clamp screw on the left
2
Needle clamp screw on the right
* Use HA-1SP #14 Needle or #11.
To attach the needle on the right :
Insert a new needle into the needle clamp with the flat side
to the back until the top of the needle touches the stopper
pin, then tighten the needle clamp screw on the right.
To attach the needle on the left :
Insert a new needle into the needle clamp with the flat side
to the back until the top of the needle touches the edge of
the needle bar, then tighten the needle clamp screw on the
left.
* When the needles are set correctly, the left
needle is higher than the right one.
* Use HA-1SP #14 Needle or #11.
1
Needle clamp
2
Needle
3
Needle stopper pin
4
Edge of needle bar
5
Needle clamp screws
6
Flat side to the back
* Do not use any needle which is bent or blunt.
Raising or Lowering the Presser Foot
By raising or lowering the presser foot lifter, the presser
foot goes up or down.
* While in operation, keep the presser foot lowered
except when threading the machine or test-
running without threads.
1
Presser foot
2
Presser foot lifter
Janome Serger
9002D Owners Manual/ User Guide