Télécharger Imprimer la page

Nespresso VERTUO POP XN9201 Mode D'emploi page 47

Publicité

9 Light blinks while machine is
running.
10 Light blinks and machine is not
running.
11 Light blinks alternately 2 blinks
and 1 pause continuously.
Machine is not running.
12 Light alternately blinking
3 times and then steady on.
VERTUO PLUS
7b Coffee leakage.
 FR 
VERTUO NEXT / VERTUO POP / VERTUO PLUS
1
Aucun voyant n'est allumé sur
le bouton.
2
Le café et l'eau ne s'écoulent
pas.
• If coffee is flowing normally, this indicates the machine is working
properly.
• If only water is flowing, the machine is executing a user request for either
cleaning, descaling or emptying the system. Refer to the corresponding
paragraph in this user manual.
• Turn the machine to "OFF mode" by pushing the button for 3 seconds and
then push it again to turn the machine ON. Now wait approximately
20 minutes to allow the machine to cool down after extensive use.
• It will take some time before the coffee flow comes out (due to barcode
reading and pre-wetting the coffee).
• Check that a fresh capsule is inserted in correct position, that the handle is
properly locked and push the button to start.
• Fill the water tank and push button to start.
• Turn the machine to "OFF mode" by pushing the button for 3 seconds
and then push it again to turn the machine ON. Now wait approximately
20 minutes to allow the machine to cool down after extensive use.
• During regular Coffee/Espresso preparation: 1) Unlock the handle and
open the machine head to check that a fresh undamaged capsule is
inserted in the correct position.
2) Check that the handle is in "LOCKED" position. 3) Check that the water
tank is filled.
• During Descaling, Emptying and Cleaning: 1) Check that capsule is
ejected. 2) Check that the handle is in "LOCKED" position.
• During Programming Volume: 1) Check if a capsule has been well inserted.
2) Please refer to the corresponding chapter.
• If problem persists:
1. Unlock the handle and open machine head.
2. Replace capsule (if needed).
3. Disconnect powercord from the outlet and plug the machine back into
outlet after 10 seconds.
4. Close the head and press the button to turn ON and press again to start
brewing. If problem persists, call Nespresso.
• Descaling needed: machine can be operated when alert appears only a
few times after this alert before descaling becomes necessary.
• Open the machine head and let the capsule be ejected. Then perform a
cleaning.
• Empty and clean the cup support.
• Descale if necessary.
• If problem persists, call the Nespresso Club.
• La machine s'est éteinte automatiquement ; appuyez sur le bouton ou
déverrouillez la machine.
• Vérifiez l'alimentation secteur, la prise, la tension et le fusible.
• Vérifiez que le réservoir d'eau est rempli.
• Vérifiez qu'une capsule neuve est correctement insérée et que la poignée est
bien verrouillée. Appuyez sur le bouton pour démarrer la préparation du café.
• Procédez au détartrage de la machine si nécessaire. 
• Ouvrez la partie supérieure de la machine ; la capsule est éjectée
automatiquement. Lancez ensuite la procédure de nettoyage conformément
aux instructions figurant à la section « Nettoyage » du présent guide.
47

Publicité

loading

Ce manuel est également adapté pour:

Vertuo plus xn9201Vertuo next xn9201