GYS PROTIG 231L DC PFC Mode D'emploi page 34

User manual
COOLING UNIT MENU (ACTIVATION / DEACTIVATION)
To access the cooling unit menu, press button
operating the main incremental encoder and press button
or «OFF» with the main incremental encoder and pressing button
RECOMMENDED COMBINATIONS
0.3 - 3 mm
2.4 - 6 mm
4 - 8 mm
6.8 - 8.8 mm
9 - 12 mm
COMPATIBLE TORCHES AND TRIGGER BEHAVIOURS
DB
L
Trigger Double Buttons
DB
For the 1 button torch, the button is called «main button».
For the 2 buttons torch, the first button is called «main button» and the second button is called «secondary button».
P
t
t
Main button
Main button T1
T1
t
t
Main button
T1 T2
Main button
T1 T2
t
t
Main button
T1 T2
Main button
T1 T2
or
or
Secondary button
Secondary button
34
Translation of the original
instructions
for more than 3 seconds. The product then displays «SEt». You must then select «CoU» by
Current (A)
3 - 75
60 - 150
100 - 200
L
170 - 250
225 - 300
DB
L
Double Buttons + Potentiometer
P
2T MODE
t
t
T2
T2
4T MODE
t
t
T3
T3
<0.5s <0.5s
<0.5s <0.5s
T3
again to confirm this choice. Activate or deactivate the Cooling Unit by selecting «On»
to confirm the choice.
Electrode (mm)
1
1.6
2
2.4
3.2
P
T1 - The main button is pressed, the welding cycle starts (PreGas,
I_Start, UpSlope and welding).
T2 - The main button is released, the welding cycle is stopped
(DownSlope, I_Stop, PostGas).
For the double button torch and in 2T mode only, the secondary button
works like the main button.
T1 - The main button is pressed, the cycle starts from the PreGas and
stops in the I_Start phase.
T2 - The main button is released, the cycle continues in UpSlope and
in welding.
T3 - The main button is pressed, the cycle switches to DownSlope and
stops in I_Stop.
T4 - The main button is released, the cycle ends with PostGas.
For the dual-button torch, the secondary button is inactive.
T4
T4
>0.5s
>0.5s
t
t
T4
T3 T4
PROTIG 231L DC PFC
Shroud (mm) Argon flow rate (L/min)
6.5
8
9.5
11
12.5
6 - 7
6 - 7
7 - 8
8 - 9
9 - 10