Installation Of Transmitter, Remote Version - INTEGRA Metering AMFLO SONIC UFA-280 Instructions De Montage Et Mode D'emploi

Installation of transmitter, remote version

Installation of wall/pipe bracket
Loosen the 2 screws on each side of unit and remove transmitter.
Mount wall bracket in an appropriate place taking coaxial cable length into con-sideration, and allowing adequate space for cable inlets
underneath and on both sides.
Connection of transducer cables
AMFLO SONIC UFA-280 is supplied with 4 separate cables. Cables can be used on all transducers (cables are not paired with a specific
®
transducer).
Snap out connection plate and loosen grounding wire.
AMFLO SONIC UFA-280
®
Cables are manufactured with crimp on cable ends. Smoothly
push cables one by one from underneath the base through
glands and adjust all four cable ends approximately 100 mm
from upper frame of base (see figure).
27