Corsair HS55 WIRELESS CORE Mode D'emploi page 3

ENGLISH
RF WIRELESS MODE
PC - Connect the wireless USB receiver to any USB (type-A) port on your PC. Press the power button on the
headset. The headset powers on in RF wireless mode by default. The headset is designed to operate at a range of
up to 50 feet (15.24m) from the receiver, but other wireless devices, electronics and obstructions such as walls may
impact performance.
Note: The first time you use the CORSAIR HS55 WIRELESS CORE headset on a PC, the operating system will
automatically install a device driver. After the device driver is installed, we recommend you reboot your PC
before use.
PLAYSTATION - Connect the wireless USB receiver to any USB (type-A) port on your PS5 or PS4 console. Use the
PlayStation settings menu to set "Output to Headphones" to "All Audio" and adjust volume control (Headphones) to
maximum level. Then adjust volume with the headset volume control.
BLUETOOTH MODE
®
With the headset powered on, enable pairing by holding the MFB until the status LED rapid blinks red and blue.
When the headset is paired, the status LED will blink blue. Quick press the power button to toggle between RF
wireless and Bluetooth modes. When the headset is in RF wireless mode the status LED will blink red, orange
or green depending on the current battery level. Note when the headset is in RF wireless mode and paired via
Bluetooth with a mobile phone, it will only accept and receive phone calls. Quick press the power button to enter
Bluetooth mode and enable both phone calls and Bluetooth audio (such as when listening to music). The headset
will default to the last mode it was set to when turned off.
ANSWERING AND ENDING PHONE CALLS
To answer an incoming call, single press the MFB. To end the call, single press the MFB again.
LISTENING TO MUSIC (MEDIA PLAYBACK)
To play a track, single press the MFB. To pause playback, single press the MFB again. To skip forward, press the
MFB twice quickly. To skip backwards, press the MFB three times quickly.
FOR OPTIMAL WIRELESS PERFORMANCE
• Place the USB wireless receiver in an open, unobstructed area.
• Make sure the battery is fully charged before initial use.
• Do not leave the battery fully discharged for long periods. Battery life is maximized by keeping the battery in a
partially charged state.
• Keep the headset at room temperature (20-30°C or 68-86°F).
NOTE: Prolonged listening at high volumes may adversely affect your hearing. Take breaks between sessions and
always begin with the volume at a low level before increasing.
2