Interrupting a programme
Depress the Start/Pause button to interrupt a programme which is running, the
corresponding light starts to flash. Depress the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «UIT/ARRET» (Off) to cancel a programme which is
running. Now you can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the Start/Pause button.
if the «Door»
●
if the «Door»
●
heating, that the water level is above the bottom edge of the door. In this
case the door can not be opened.
If you cannot open the door but you need to open it, you have to switch the
●
machine off by turning the selector dial to «UIT/ARRET» (Off).After about 3
minutes the door can be opened (pay attention to the water level and
temperature!).
At the end of the programme
The machine stops automatically, the Start/Pause button pilot light goes off, a
flashing
0
appears on the display and the acoustic signal sounds for 2 minutes.
If the Rinse Hold
symbol is still on and the door remains locked to indicate that the water must be
emptied out before opening the door.
To empty out the water please read the steps on the Rinse Hold option
paragraph.
Turn the programme selector dial to «UIT/ARRET» (Off) to switch the machine off.
Remove the laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the
door open to prevent the formation of mildew and unpleasant smells.
symbol disappears, the door can be opened.
symbol doesn't go off, it means that the machine is already
or Night Cycle option has been selected, the «Door»
Downloaded from www.vandenborre.be
use
73