Sony STR-DA4400ES Mode D'emploi page 88

3
Press ZONE.
The remote switches to zone 2 or zone 3.
Change the zone setting of the remote to
zone 3 in advance (page 87).
4
Press ?/1.
The zone function is activated.
5
Press one of the input buttons
on the remote to select the
source signals you want to
output.
For zone 2, analog video and audio
signals are output. For the zone 3, only
analog audio signals are output. When
you select SOURCE, the signals of the
current input of the main zone are output.
6
Adjust to a suitable volume.
• In the case of illustration 1-1
(page 84), adjust the volume using
MASTER VOL +/– on the remote.
• In the case of illustration 1-2 (page 84)
or 2 (page 85), adjust the volume using
the receiver of zone 2 or zone 3.
To finish the zone 2/zone 3
operation
Press ?/1 after pressing ZONE.
Tips
• Even when this receiver is standby mode (press
?/1 on the remote to turned off this receiver), the
receiver in zone 2 or zone 3 remains turned on. To
turn off all receivers, press ?/1 and AV ?/1 on the
main remote at the same time (SYSTEM
STANDBY).
• Only signals from components connected to the
analog input jacks are output through the ZONE 2
or ZONE 3 jacks. No signals are output from
components connected to only the digital input
jacks.
• When SOURCE is selected, the signals input to the
MULTI CHANNEL INPUT jacks are not output
from the ZONE 2 OUT or ZONE 3 OUT jacks
even when the multi-channel input is selected. The
analog audio signals of the current function are
output.
88
GB