VM Motori R756EU6EH Manuel D'instructions Pour L'emploi page 90

SAFETY WARNINGS FOR THE ELECTRICAL EQUIPMENT
The electrical equipment was designed and
manufactured according to the provisions of
GB
the standards in force on the matter.
IMPORTANT
- Do not use quick starters to start the
engine.
- Do not disconnect the electrical power
supply when the engine is running.
RESIDUAL RISKS
During the engine design and manufacture phases, the manufacturer paid special
attention to the aspects which may cause any risk for the safety and health of people
interacting with the engine.
Despite this, some potential and hidden risks still exist.
DANGER - WARNING
- Danger of injury to upper limbs:
Do not put your hands inside any
moving part.
- Danger of burning/scalding:
Pay attention to hot surfaces and
radiated heat.
- Danger of electrocution:
Do not come into contact with the
electrical components, wiring harness
and other engine parts without having
removed the ignition key and waiting at
least 6 minutes before disconnecting
the negative battery cable.
English
IMPORTANT
Before disconnecting power supply,
remove the ignition key and wait for at
least 6 minutes before disconnecting
the negative battery cable.
Before performing arc welding on the
frame where the engine is installed,
ALWAYS disassemble the electronic
control unit and protect all electrically
connected devices that are installed
close to the negative pole (ground).
20
R756EU6EH
42432108F