Publicité
ELECTRIC STARTING SYSTEM
INSPECTION AND REPAIR
1. Inspect:
2. Measure:
3. Measure:
NOTE:
The mica insulation of the commutator must be
undercut to ensure proper operation of com-
mutator.
4. Measure:
Measurement steps:
Measure the armature assembly resis-
G
tances with the pocket tester.
If any resistance is out of specification,
G
replace the starter motor.
6 - 12
ELEC
Commutator
G
Dirt → Clean it with #600 grit sandpaper.
Commutator diameter a
G
Commutator wear limit:
16.6 mm (0.65 in)
Out of specification → Replace the
starter motor.
Mica undercut a
G
Mica undercut:
1.35 mm (0.05 in)
Out of specification → Scrape the mica
to the proper value (a hacksaw blade
can be ground to fit).
Armature assembly resistance (com-
G
mutator and insulation)
Out of specification → Replace the
starter motor.
Pocket tester
YU-3112-C/90890-03112
Armature coil:
Commutator resistance 1
0.018 ~ 0.022 Ω at 20 ˚C (68 ˚F)
Insulation resistance 2
Above 1 MΩ at 20 ˚C (68 ˚F)
–
+
Publicité
